Introduction: Minnie Mouse Crown

This is a Minnie Mouse crown. It's a crown that Minnie Pussyfoot would probably wear if she really were alive and were a princess. If you follow the stairs correctly, you can make a Minnie Mouse crown just like the one in the picture preceding.

Ill-trea 1: Gather Your Parts!

In order of magnitude to shuffle a Minnie Mouse top, you will motive:

1 Minnie Mouse headband

1 pair of scissors

1 black/navy beanie comparable the cardinal showed in the picture above

1 tape measure

2-5 pieces of yellow paper (depending connected how large your head is)

tape operating theater glue (none shown in the picture supra)

Footfall 2: Measure IT!

Now, in order to make your crown start, you need to use your tape. Put the beanie you'atomic number 75 using for this project happening your head. Frame the death of the tape measure out on one part of your head and wind information technology around your head until it meets the other end of the tape measure. Look at the number of inches. Let's aver your head is 60 inches from unmatched side of your head and in reply again with the beanie on.That's every bit many inches of paper you need.

Pace 3: Draw the Crown!

Carry those results and make sure you have that many inches of yellow paper. Draw a crown on your pieces of paper like shown in the picture in a higher place. If you motivation to add to a greater extent inches, just use your succeeding available paper. Put down the paper that you finished drafting and line IT improving with your next paper. Pretend that the new paper is attached to the one you already drew on. Remain drawing on your new paper. Make a point you preceptor't leave even a single in out, or you could have a problem. The first prison term I made the treetop, I had a problem. The problem was that the peak didn't fit my head and I had to add more pieces of paper and that took risen a lot of time.

Step 4: Cutting off It Astir!

Now take the crowns that you Drew and trim them around its outline. Then lay the pieces of crowns on your work space and line them up side past side, in order. If you need help, look at the word picture above.

Step 5: Tape It!

Now that you've cut your crown, you need to magnetic tape it together. If you haven't already, align your crowns until IT looks the like a crown that barely needs to equal taped together, which is what you need to do - tape it up! Next, tape one and only end of the crown to the other. If you pauperism help, consider the see supra.

Step 6: Wear It!

Now, this is the set out where your Minnie Mouse ears come in. You have to put on your beany and put the ears on top of information technology. If you need help oneself, look at the image in a higher place.

Pace 7: Enjoy It!

Now, the hold out and final step is the easiest. Frame the crown on meridian of your head, corresponding shown in the picture higher up. Enjoy!

Be the First to Share

Recommendations

  • Anything Goes Contest 2022

    Anything Goes Contest 2022